SimTel GSM/GPRS/UMTS ROBOT
Utilité
Ressources
Le boitier est axé autour du PXECORE de CompuLAB. L'OS est un VXWorks, OS Temps réel.
Ports uart, jtag
Deux UART (A & B) disponibles, dont un routé sur le connecteur /EXT BAY/ frontal.
Port JTAG disponible mais routé étrangement : deux pins sont routés vers le port RJ45 ?!
Concernant les UART je n'arrive a rien de lisible en testant les rates de 600, 2400, 9600, 115200 et intermédiaires.
- UART-A : A souder
- UART-B : 8N1 9600 /!\ semble bloquer le boot si connecté / TX seul ??
EXT BAY / RS 232
__________________________ \ 1 2 3 4 5 6 7 8 / \_9__10_11_12_13_14_15_/
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
---|---|---|---|---|---|---|---|
(GND) pin15 of ADN2202AN | (TX1) pin14 of ADN | (RX1) pin13 of ADN | Possible UNIBAY extend | UART-B GND | UART-B TX | ||
9 | 10 | 11 | 12 | 13 | 14 | 15 | |
vers relai K1 | vers relai K2 | GND ? |
Photos
Tips
Configuration réseau, boot, phones
Brancher le boitier, lorsque s'affiche “BILO …” presser une touche et rester appuyé, puis suivre les instructions.
Modes réseau
- 0: TC35 / NO BOOT
- 1: Boot from FLASH
- 2: Boot from BIN @a0060000
- 3: Boot from COFF
Ports dispos
- telnet, mdp/user a déterminer
- ftp, connexion ok, rien derrière ?
Logs
- Boot log UART-B front
Running vxWorks from a0060000... Attached TCP/IP interface to fei unit 0 Attaching interface lo0...done Attach Adding 2964 symbols for standalone. ed TCP/IP interface to fei unit 0 Attaching interface lo0...done Attach Adding 2964 symbols for stand-> alFound Oxford PCI IC #0 as bus#0, dev#5 Found Oxford PCI IC #1 as bus#0, dev#6 one. undefined symbol: alone -> -> ed TCP/IP interface to fei unit 0 undefined symbol: TCP -> -> -> Attaching interface lo0...done undefined symbol: interface -> -> -> Attach undefined symbol: Attach -> -> -> -> Adding 2964 symbols for stand-> alFound Oxford PCI IC #0 as bus#0, dev#5 undefined symbol: Adding -> Found Oxford PCI IC #1 as bus#0, dev#6 undefined symbol: Oxford -> one. unde